Arduino Pro Micro, ATmega32U4 5V

Arduino Pro Micro, ATmega32U4 5V

€8,50 €6,99
  • Availability: Out of stock
  • Delivery time:Will be shipped as soon as product is avalible again.
The Arduino Pro Micro is basically the same as the Pro Mini but with the exception that it has a Micro USB port for programming.
- 12 x Digital I/O's
- Of Which 5 PWM Capable
- 4 x ADC I/O's
- With Micro USB Port
- Input: 5 Volt DC
- 16Mhz ...More information
Out of stock
  • Gratis verzending vanaf 50 Euro
  • Verzending al vanaf 2.50 Euro
  • Kans op een gratis product dat bij jouw order past
  • Doorgaans op werkdagen, binnen 24 uur verzonden.

Product description

  • Availability: Out of stock
  • Delivery time:Will be shipped as soon as product is avalible again.
  • Unit price:€6,99 / Piece

The Arduino Pro Micro

The Arduino Pro Micro is similar to the Pro Mini except with an ATmega32U4 on board. The USB transceiver inside the 32U4 allows you to add USB connectivity on-board and do away with bulky external USB interface.


This tiny little board does all of the neat-o Arduino tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Running at 16MHz and 5V,


This board will remind you a lot of your other favorite - Arduino-compatible boards but this little guy can go just about anywhere. There is a voltage regulator on board so it can accept voltages up to 12VDC. If you're supplying unregulated power to the board, be sure to connect to the "RAW" pin and not VCC.


This latest revision corrects the silk error from the last version of the board so that pin 14 is correctly labeled. We've also added a PTC fuse and diode protection to the power circuit and corrected the RX and TX LED


The Arduino Pro Micro is also suitable for use with wa ver ywide range of avalible shields, however in order to hook up a shield on the Arduino Pro Micro you must create a Headerboard or connect the Pro Micro using module wires.



Specifications:

- ATMega 32U4 running at 5V/16MHz
- Supported under Arduino IDE v1.0.1
- On-Board micro-USB connector for programming
- 4 x 10-bit ADC pins
- 12 x Digital I/Os (5 are PWM capable)
- Rx and Tx Hardware Serial Connections

 
The Arduino Pro Micro is delivered WITHOUT a USB Cable.

Reviews

0 stars based on 0 reviews Add your review